8.3.1.2 packet tracer commands software#. This command was integrated into Cisco IOS Release 12.0(31)S. Router configuration (config-router) and address-family interface configuration (config-router-af) Command History To disable BFD for all neighbors on a single interface, use the no form of this command.īFD is disabled on the interfaces participating in the routing process. To enable Bidirectional Forwarding Detection (BFD) for all interfaces participating in the routing process, use the bfd all-interfaces command in router configuration or address-family interface configuration mode. In the following example, network numbers are not summarized automatically: router rip When automatic summarization is off, subnets are advertised. Disable automatic summarization if you must perform routing between disconnected subnets. If you are using RIP Version 2, you can turn off automatic summarization by specifying the no auto-summar y command. RIP Version 1 always uses automatic summarization. 1.3.3 Packet Tracer Configuring DHCPv4 Using Cisco IOS Addressing Table Device Packet Tracer Configuring DHCP Using Cisco IOS (Answer Version)nswer Note. cisco ccna routing and switching complete video. Route summarization reduces the amount of routing information in the routing tables. 8.3.1.2 Packet Tracer - Skills Integration Challenge CISCO - CCNA Routing and Switching - Routing and Switching Essentials Packet Tracer. Support in a specific 12.2SX release of this train depends on your feature set, platform, and platform hardware.

This command is supported in the Cisco IOS Release 12.2SX train.